The BitSoftware team have been hard at work developing some new modules!
A new module has been released for BitEdit:
Module for editing and tuning of Bosch ME17.8.5 ECUs.
The following maps are available for editing:
- Airmass flow calculation over throttle valve
- Idle speed control
- Enrichment and enleanment at acceleration and deacceleration
- Injection timing control
- Mixture control
- Target lambda for knock protection
- Spark advance optimal and base, advance correction
- Ignition efficiency
- Lambda efficiency
- Optimal torque
View Full Range of modules here.
Also two new modules have been added to the BitBox flasher.
BitBox Rotax Extreme Flasher Module.
Siemens MSE 3.7x.
Allows identification, reading of full flash and writing of the calibrations areas by K-Line. It also supports automatic correction of checksums while writing.
Siemens MSE 3.7 with MCU ST10F269 and internal Flash memory 256Kb.
Siemens MSE 3.71 with MCU ST10F269 and internal Flash memory 256Kb.
Bosch ME17.8.5.
Allows identification, virtual reading of full flash (from internet server) and writing of the calibrations areas by CAN bus. It also supports automatic correction of checksums while writing.
ECU is based on MCU Infineon Tricore TC1762 with internal Flash memory 1504Kb.
BitBox Chrysler / Dodge / Jeep Petrol Flasher Module.
Allows identification, reading of full flash and writing of the calibrations areas by CAN bus. It also supports automatic correction of checksums while writing.
- Motorola NGC3 MPC565 1Mb
- Motorola NGC4 MPC5554 2Mb
- Motorola NGC4A MPC5566 3Mb
- Continental GPEC (SIM90) MPC561+EXT.FLASH 2Mb – beta version
- Continental GPEC2 MPC5566 3Mb – beta version
- Continental GPEC2A MPC5566 3Mb – in development, not yet released!
Click here for more info!
View Full Range of modules here.
